Dynamo Hub Cable Routing

After the dynamo cable has run up the inside of your fork it makes sense to keep the internal wiring right through to the back of the bike.

Dynamo hub cable routing. Dynamo cable routing ratherbeintobago. If only there was a hub that was the perfect. Internal dynamo cable routing. Unsightly cables disappear seamlessly into the crown through a small hole and then re appear on the inside of the non drive side fork leg just above where the dynamo cables plug into the dynamo hub.

Busch müller schmidt and spanninga headlights have small spade connectors on the bottom which are used to connect to a taillight. Run the cable coming out of the steerer tube parallel to the existing cable of the front light down to the hub dynamo. This is actually not as hard as you d think given there are holes in the ends of most frame tubes. Our design allows for a second cable to run an additional device such as a dynamo powered usb charging point so you can power multiple lights and.

The usb reactor and k lite top cap switch were modified to run internally and thus exit down the steerer tube by passing closely past the star nut. Anyone any suggestions for routing dynamo wires on a suspension fork that looks neater cable ties. Since the surly krampus was in no way intended to handle internal cable routing for a dynamo hub i had to get creative. For those interested the switch was 3d printed and wired to provide usb or.

If the power source is a dynamo hub rather than a sidewall dynamo the taillight should be wired to the headlight not to the dynamo hub. Only the headlight is wired to the hub. Posted 5 years ago.